Bathroom. Tuesday , July 18th , 2017 - 15:23:59 PM
However, if you’d rather not draw too much attention to the bathroom faucet, you could opt for something simpler such as the Edge 35 model. It has clean and simple lines defined by a waterfall system. It’s only a simple modification brought to a modern design but it makes all the difference.
If your shelf isn’t traveling from wall to wall, consider cutting a 45-degree angled corner off the protruding corner. This is entirely optional, of course, and it does add some complication and effort in trimming out the shelf edge. But it makes for a nice, polished, and softer edge. (Particularly if your above-door shelf, like this one, is readily visible in a mirror or other reflective surface.)
Screw on all four female couplers to the four mixing valve threads. Determine whether or not you will be raising your mixing valve. Technically, this can be positioned as high up on the wall as you want it. For a shower alone, you would obviously want the mixing valve to be much higher than for a tub/shower combination because it doesn’t need to be accessed for bathtub use. Hold the mixing valve into place where you want it and mark the nearest stud at the vertical center of the valve. Measure the vertical distance from the old mixing valve to the new position; you will need to cut two pipes this length to raise the cold and hot water pipes to this height. Also, measure the new distance from the bottom female coupler on your mixing valve to the horizontal pipe connecting the tub faucet.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does artforcritters.net claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.